Re: Able to getfile, but unable to put file? (General questions)

by Wee Ping, Tan, Friday, February 03, 2006, 08:05 (6683 days ago) @ wodSupport

Wee,

from ListParams property

http://www.weonlydo.com/FtpDLX/Help/wodFtpDLXLib~wodFtpDLX~ListParams.html

set Ftp1.ListParams = and try again.

Kreso

Hi Kreso,
as advised, the error was gone after I set listparam =
however the putfile operation still fails.

220-QTCP at ATLANTIS.
220 Connection will close if idle more than 5 minutes.
USER XXX 331 Enter password.
PASS XXXX 230 XXX logged on.
FEAT 211-Feature listing follows:
AUTH TLS
PBSZ
PROT
211 End of feature listing.
PWD 257 QGPL is current library.
TYPE A 200 Representation type is ASCII nonprint.
PASV 227 Entering Passive Mode (10,223,156,90,190,71).
LIST QGPL 125 List started.
LIST QGPL 250 List completed.
CWD QGPL 250 QGPL is current library.
TYPE I 200 Representation type is binary IMAGE.
PASV 227 Entering Passive Mode (10,223,156,90,240,94).
STOR QGPL 550 Not authorized to access library QGPL.

[color=#abcdef]STOR QGPL 550 Not authorized to access library QGPL.
[/color]
Is this due to access rights? But I am able to manually FTP get and put file via command prompt. with the same user ID and password.

?