Re: SSH towards Cisco - WeOnlyDo Discussion board

Re: SSH towards Cisco (General questions)

by dirk, Thursday, March 17, 2011, 18:43 (4811 days ago) @ wodDamir

Dirk,

This is related to SSH or Telnet protocols?

When Command property is used in SSH, the component will only disconnect once the command is executed.

However, why don't you connect, and execute commands using Send or Execute/WaitFor methods?

Regards,
Damba

It's the SSH protocol.
Not sure about the send/execute/waitfor options.
I suppose that I should then wait for the prompt, send the command and wait again for the prompt?


Complete thread: